Advertisement
Rudder Support Bar into the location hole in the Fuselage Brace with care that the Rudder Bar will
turn freely on the shaft once the glue has set. Next gather the two (2) Black Rudder Bar lines straight
back into the cockpit area for now. Tie off the gray lines to the Fuselage Frame Loops for the rear
lines and the forward lines to the forward Fuselage joints. See picture below.
Glue the Magneto and Oil Pump to the rear side of the Cowl Frame Camshaft Support location holes
with the Magneto on the right side and the Oil Pump on the left side as seen in the picture below.
Make sure they are arranged on a vertical orientation as seen in the picture below on the right.
Tie four (4) gray lines on the four (4) corners of the Leather Pad then tether the Pad positioned just
below the air filter attaching to the loops on the Fuselage Frame as seen in the picture on the next
page with the view looking up through the bottom of the Fuselage.
Locate the seat assembly parts: the photo etched Seat Back, cast metal Seat Cushion, Seat Frame,
Seat Base and four (4) Pins. First, brush the aluminum Seat Back horizontally on both sides to
simulate brushed aluminum taking care not to bend or distort the tabs. Next adjust and form the Seat
Back Frame and glue to the Seat Cushion indexing the locating pins on the Frame into the locating
holes on the Cushion. Now glue the four (4) Pins in place by inserting the Pins into the holes in the
Seat Cushion and add the glue to the Pins on the bottom side of the Seat Cushion. Once the glue
sets completely cut off the excess Pin shafts and add a drop of glue onto the cut off Pins. See pictures
on the next page. Glue the Seat Base to the Seat Cushion indexing the locating pins on the Base
15
Advertisement
