Lynx Enduro 400 F Owner's Manual page 174

1. Notch
Governor cup has 6 positions numbered 2 to 6. Note that in position 1 the number is substi-
tued by a dot (due to its location on casting).
1. Position 1 (not numbered)
Each number modifies maximum engine RPM by about 200 RPM.
Lower numbers decrease engine RPM in steps of 200 RPM and higher numbers increase it
in steps of 200 RPM.
EXAMPLE:
Calibration screw is set at position 4 and is changed to position 6. So maximum engine
RPM is increased by 400 RPM.
To adjust:
Just loosen locking nut enough to pull calibration screw partially out and adjust to desired
position. Do not completely remove the locking nut. Torque locking nuts to 10 Nm.
OPERATOR'S GUIDE 49