Lynx Enduro 400 F Owner's Manual page 169

CLEANING
Clean the battery, battery casing, cables and battery posts with baking-soda solution.
Remove rust form battery cable connectors and battery posts using firm wire brush.
WARNING!
Do not place the battery near the open flame.
INSTALLATION
Place the battery to battery holder.
Attach the battery fastening strap and make sure that negative cable is installed as shown in
the picture below.
1. Negative cable under the battery strap
WARNING!
Always connect the battery cables excatly specified order. Connect RED positive cable
first, then BLACK negative ground cable.
Add dielectric grease (P/N 413 701 700) on battery posts and connectors.
Battery charging
Battery electrolyte amount has to be between upper and lower marks.
If the liquid gets under MIN-mark, add destillated water up to MAX-mark.
44 OPERATOR'S GUIDE