Lynx Enduro 400 F Owner's Manual page 164

STEERING Handlebar bolts retorque 26 Nm
Steering and front suspension mechanism lubrication**
Control of TA-shocks condition
TA-shocks service and oil change(once a year)
Wear and condition of skis and runners
Steering and ski leg camber adjustment
REAR Suspension adjustments
SUSPENSION Suspension lubrication**
Suspension condition (also slide rails and wheel bearings)
Control of TA-shocks condition
TA-shocks service and oil change(once a year)
Suspension stopper strap condition
Track condition
Track tension and alignment
ELECTRICAL Spark plugs cleaning (change 2500 and 4000 km)
SYSTEM Engine timing
Battery condition
Headlight beam aiming
Wiring harnesses, cables and lines
Operation of electrical system
HI/LO beam, brake light, etc.
Test of emergency cut out switch and tether cut-out switch
OTHERS Add grease to all nipples and oil all ball joints
Check and tighten all bolt connections
General cleaning and control
Modifyings/actions according to service bulletins
Test and start the engine
* Before installing new spark plugs at pre-season preparation, it is suggested to burn excess storage oil by starting the
engine with the old spark plugs. Only perform this operation in a well ventilated area.
** Lubricate whenever the vehicle is used in wet conditions (wet snow, rain, puddles)
OPERATOR'S GUIDE
1 2 3 4 5 6
x
x x x
x x
x x
x x
x x
AS REQUIRED
x x
x x
x x
x
x
x x
x AS REQUIRED
x x x
x x
x x
x
x x x
x x x
x
x x
x
AS REQUIRED
x x x
39