Omron ZX2 Manual page 4

Amplifier and Calculating Unit
Ease of Use by "LED Display" and "Calculating Unit"
11-segment LED display for intuitive configuration
Determination output indicators
High (orange)/Pass (green)/
Low (orange), two color display
11 Segment LED Display
No need for a manual
11 Segment LED Display
An 11 segment LED display is integrated
in the compact housing. Alphanumeric
characters can be read with ease and
there is no need to refer to a manual.
Perform two calculations with ease
Thickness + subtraction mode
The calculated results of two sensor heads are displayed on the amplifier unit by just connecting the calculating unit between
the two amplifier units. The calculation function can be chosen from the two modes of thickness and subtraction. It is also
possible to prevent mutual interference by coupling via the calculating units. (Up to five amplifier units can be connected.)
Sensor 1
Thickness mode
Sensor 1 0 criterion
Sensor 2 0 criterion
Sensor 2
Thickness
Easy change of setup
Equipped with 4 banks
Existing models
The amplifier unit is equipped
with four bank functions.
Easy change of setup between
four modes is supported by
just switching between the
bank functions.
Intuitive operation through
cross buttons
Comparison of the existing 7 segment LED display and
the 11 segment LED display
The 7 segment display
on existing models
30mm
31mm
64mm
The compact housing stays just as it is
Subtraction mode
A
K T
B
T = K + ( A + B )
Amplifier unit
+
Bank unit
Easy calculations of measurements
The 11 segment display
on model ZX2
30mm
38mm
72mm
S
A
B
Level difference S = B - A
ZX2
B A N K
3
B A N K
2
1
B A N K
0
Built into the unit
ZX2
4