Tools You Will Need; Mounting Space - GE Profile Advantium SCA2001KSS Installation Instructions Manual

TOOLS YOU WILL NEED

# 1 and #2 Phillips screwdriver
Tin snips (for cutting
damper, if required)
Gloves
Safety goggles

MOUNTING SPACE

"
16- 1 ⁄
8
30"
2 "
66" or more
from the floor
to the top
of the oven
Installation Instructions
Pencil
Scissors
(to cut template, if necessary)
Saw (saber, hole or keyhole)
Bottom edge of
cabinet needs to
be 30" or more
from the cooking
30"
min.
Backsplash
Ruler or tape measure
and straight edge
Electric drill with 3/16, " 7/16, "
1/2" and 5/8" drill bits
Stud finder or Hammer (optional)
Level
NOTES:
• The space between the cabinets must be 30" wide
and free of obstructions.
• If the space between the cabinets is greater than
surface
30", a Filler Panel Kit may be used to fill in the gap
between the oven and the cabinets. Your Owner's
Manual contains the kit number for your model.
• This oven is for installation over ranges up to
36" wide.
• If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions on
the top cabinet template for power cord clearance.
• For best installation results, we recommend a
maximum cabinet depth of 12".
7
Carpenter square
(optional)
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed bottom
cabinet installations only)
Duct and masking tape