Boutside Back Exhaust; Outside Back Exhaust; Back Exhaust - GE Profile Advantium SCA2001KSS Installation Instructions Manual

B

OUTSIDE BACK EXHAUST

INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Mounting Plate to Wall
B3. Prepare Top Cabinet
B4. Adjust Blower
B5. Mount the Oven
PREPARING THE REAR WALL
B1
FOR OUTSIDE BACK EXHAUST
Place the mounting plate against the rear wall and
1
align it with the holes drilled earlier.
Using a pencil, put dots through slots F and G, and
2
through holes H and I. Remove the mounting plate
and draw lines extending through the points. This will
give the lcoation and size of the box cutout for the
rear wall duct.
F
H
Installation Instructions
G
I
15
(Horizontal Duct)
Attach the exhaust adaptor to the rear mounting plate
3
by sliding it into the guides at the top center of the
plate on the wall side.
Exhaust Adaptor
Slide Exhaust
Adaptor Into
Guides on
Rear Panel
Push in securely until it is past the top locking tabs and
in the lower locking tabs. Take care to assure the damper
hinge is installed so that it is at the top and that the
damper swings freely.
Carefully guide the exhaust adaptor, now attached to
4
the mounting plate, into the house duct, before using
the screws to attach the plate to the wall.
Damper
(hinge side up)
Mounting Plate
(wall side)
Locking
Tabs
Guides