Boutside Back Exhaust; Outside Back Exhaust; Attach Mounting Plate To Wall - GE Profile Spacemaker JVM3670 Installation Instructions Manual

B

OUTSIDE BACK EXHAUST

INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Mounting Plate to Wall
B3. Prepare Top Cabinet
B4. Adjust Blower
B5. Mount the Microwave Oven
PREPARING THE REAR WALL
B1.
FOR OUTSIDE BACK EXHAUST
F
H
1 Place the mounting plate against the rear wall and
align it with the holes drilled earlier.
2 Using a pencil, put dots through holes/notches F,
G, H and I (see above illustration). Remove the
mounting plate and draw lines extending through
the points. This will give the location and size of the
box cutout for the rear wall duct.
3
Use a saw (saber or keyhole) to cut out the opening.
4
Place the microwave in its upright position with the
top of the unit facing up.
Installation Instructions
G
I
15
(Horizontal Duct)
This microwave oven is shipped assembled for top
exhaust. You will need the exhaust adaptor for
installation in the rear wall opening. To remove the
exhaust adaptor from the microwave oven:
Remove tape securing damper.
5
6
Remove and
save screw
that holds
blower plate
to microwave.
8 Slide exhaust adaptor to one side and remove it.
7
Lift off the
blower plate
and attached
Damper
adaptor from
the microwave.
Back of
Microwave