Table of Contents
Advertisement
RE300 model installation
Unpack the main unit of RE300 and install it on the level area.
Refer to the instruction manual of VR300 model vacuum controller (sold separately) if connected.
Connection on back surface area
Connect the vacuum hose and cooling hose to the condenser.
Use the vacuum hose and cooling hose with inner diameter of 6mm and 9mm respectively.
Connect the hose to the vacuum pump and cooling water circulation system so they should not be
pulled when the lift on the main unit moves upwards.
Refer to 2.3) mentioned below for the piping method of hose.
Installation example: RE300AW
DC power cable connector for the
VR300 model vacuum controller
and TA300 model evaporating
temperature indicator
Main switch of rotary evaporator
(also used as a circuit breaker)
○: OFF I: ON
Plug the attached power cord securely.
8
Installation Method
Advertisement
Table of Contents
