Table of Contents
Advertisement
Description and Function of Each Part
Other Functions
Rotary evaporator drive unit
The glass unit goes up and down by operating the lift
up/down key. During the auto operating of RE800, it
automatically goes up and down by operating the
START/STOP key on the VR vacuum controller.
Rotor
It starts, stops and adjusts the rotation of rotary joint
(sample flask) by the operation of rotation control
knob.
Lift lower limit position control knob
It adjusts the lower limit position of lift when it is
lowered.
Move the lift to the uppermost position.
Loosen the knob, push up to the proper position and
then tighten it again to change the lowermost position
of lift.
Lift release knob
It is used to manually operate the lift at power failure,
Glass set and bath are sold separately.
or when it does not move smoothly.
Turn the knob counterclockwise to loose it to operate
the lift manually.
Turn the knob clockwise to tight it to operate the lift
automatically.
Note: The lift does not move up and down by the key
operation if the knob is loose. In this case, tighten it
firmer clockwise.
Adjuster
It is used to adjust the level of rotary evaporator.
21
Advertisement
Table of Contents
