Re600/800 Model Installation - Yamato RE300 Instruction Manual

RE600/800 model installation

Unpack the main unit of RE300 and install it on the level area.
Refer to the instruction manual of vacuum controller for the installation of VR600/800 model vacuum
controller.
Connect the VR600 model vacuum controller and VR800 model vacuum controller to the RE600 model
and RE800 model respectively.
Connection on back surface area
VR600/800 model
vacuum controller
Use the vacuum hose and cooling hose with inner diameter of 6mm and 9mm respectively.
Connect the hose to the vacuum pump and cooling water circulation system so they should not be
pulled when the lift on the main unit moves upward
Installation example: RE800AW
DC power output connector for
vacuum controller
Signal cable connector between
main unit of device and vacuum
controller
Main switch of rotary evaporator
(also used as a circuit breaker)
○: OFF I: ON
Plug the attached power cord securely.
9
Installation Method