Houghton BELAIRE H2000 Owner's Manual page 8

Installation position
Before the installation, consider the installation position:
● The air-conditioner shall be installed in the center of
the roof to deliver even air flow within the caravan.
● The installation position of the outdoor unit shall be
consistent with the traveling direction of the caravan.
● When installing ensure that there is sufficient room for
the plenum assembly to be installed.
● Consider the installation position and ensure that
outlets are at least 400mm (16") away from cupboards,
walls & bulkheads that can redirect conditioned air
back to the return air intake. If an outlet is closer than
400mm from an obstruction, then it should be sealed
closed. Failure to do this will result in a unit that
frequently cycles on and off.
/
● 360 × 360mm/ 14 3
16
avoid roof cladding joints where ever possible.
Angle of inclination of the air-conditioner shall not be greater than 5° and the rear of the air-conditioner shall
not be higher than the front.
For advice on installations outside of these limits please contact HOUGHTON or the local distributor.
● The figure below shows the minimum clearance distance required between the BELAIRE air-conditioner and any
obstructions on the roof and the clearance required on the ceiling for the plenum installation. Measure from the
reference position of the 360 × 360mm / 14
around roof top unit perimeter.
567
/
3
× 14 " cutting position shall
16
536
360
283
1002
Traveling direction of the caravan
● There shall be a space of 100mm/4" minimum all
around the roof top unit to ensure suitable air flow and
access for maintenance.
Note
/ / " square hole. Remember to add 100mm / 4" clearance
3 3
× 14
16 16
294
114
360
557
5
Front
Plenum position
Direction of travel
Square hole (360× 360mm)
Position of rooftop unit
Back
Unit: mm