Safety Notes - Houghton BELAIRE H2000 Owner's Manual

Make sure the external electric supply socket of the caravan air-conditioner is effectively
grounded in accordance with your local regulations.
Failure to ground the unit correctly may cause electric shock or fire.
The caravan air-conditioner shall be switched on for electric leakage detection after
installation.
If you are not to use the air-conditioner for a long time, please isolate the power supply.
Clean the filter of the air-conditioner regularly. A dirty filter will decrease air flow and
lead to poor heating and cooling performance.
Use the remote control to operate the air-conditioner.
Install the air-conditioner in compliance with the instructions of this manual.
Incorrect installation methods or alteration of the product may cause damage to the
product or personal injuries to the user.
Be careful when installing the unit on the roof of the caravan, crawl boards may be
required.
There may be wires between the roof and the ceiling. When cutting into the roof, make
sure the power is isolated prevent risk of electric shock.
Installation and maintenance of the air-conditioner must only be performed by personnel
with appropriate trade qualifications and holding current licenses for such work.
Do not over-tighten the power connection terminals.
Ensure that your electrical supply and wiring is correctly sized for the power demand of
the air-conditioner. Refer to the product specifications.
This appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge. Children
are not to play with this appliance and should be supervised at all times.
It may not be operated in vehicles while driving.
Keep the air inlet and outlet of the inside and outside units of the air-conditioner
clear.
Do not spray any paint or insecticide on the surface of the air-conditioner.
Immediately turn off the air-conditioner and isolate power supply if there is any unusual odour,
smoke or fire detected. Contact after-sales service personnel in case of unit fault and fire.

Safety Notes

1