Houghton BELAIRE H2000 Owner's Manual page 17

When in the AUTO mode, according to the difference between the setting temperature and the
environmental temperature , the plenum will display
(automatic cooling) in the same time.
" "
and
Celsius and Fahrenheit degree change
● In any mode，Press the ℃/℉ key to select temperature units of Celsius or Fahrenheit.
Turn off
● Press the on/off
Timing function
● Set clock and timer.
Press the "SET TIME" key, the Hour digit will flash. Press "▲"or"▼"key to set hour. Press the "HOUR/MIN" key,
1
the Minute digit will flash. Press"▲"or"▼"key to set minute. Clock setup is done.
2 Press the " SET TIME " key, until "ON" shows on the upper right side of the clock and hour digit flashes. Then press
the "HOUR/MIN" key, and "▲"or"▼"key, to set the desired time to turn the unit on.
Press the SET TIME" key, until "OFF" shows on the lower right side of the clock and hour digit flashes. Then press
3 "
the "HOUR/MIN" key, and "▲"or"▼"key, to set the desired time to turn the unit off.
4
Clock and timer is now set. Keep on pressing the SET TIME" key to check again clock and programmed time to turn
unit on and off. When all setup is done, after 10 flashes, it will return to clock display.
● Timing to turn on : Press the"TIMER" key until "ON" flashes and shows the time to turn on. When "ON" is displayed
after its 10 flashes, and only current clock is displayed, then the setup of timing to turn the unit on is done.
● Timing to turn off : Press the "TIMER" key until "OFF" flashes and shows the time to turn off. When"OFF" is displayed
after its 10 flashes, and only current clock is displayed, then the setup of timing to turn the unit off is done.
● Timing to turn on and off : Press the "TIMER" key until "ON" and "OFF" flashes simultaneously and shows the time to
" "
°C /°F
" " key again， unit turns off and the plenum and remote control will be blank.
Note
" "
" "
and
"
14
(automatic heating), or
" "