Houghton BELAIRE H2000 Owner's Manual page 18

turn off. When "On" and "OFF" are displayed after their simultaneous 10 flashes, and only current clock is displayed, then
the setup of timing to turn the unit on and off is done.
● Turn off timing function: Press the "TIMER" key, when it only shows the clock, the timer function is turned off.
● Simple method to reset the timer function : remove battery from the remote control , and then replace , The remote
control will be restored to the factory settings, and the timer function is turned off.
2. Plenum operation
Basic air-condition features can be accessed via the plenum control. This is useful if the remote control has been
lost or is not functioning .
● Press the touch screen
->HEAT " modes with each touch. The set point temperature is 24°C with high fan speed.
● The plenum display will show symbols for each function：
" " , DRY
COOL
Operation of the air- conditioner using the plenum control can be be prevented by pressing
"LOCK" on the remote control. Press the "LOCK" key on the remote control again to unlock.
● The remote control should be operated by directing it towards the plenum, which will
beep once when a signal is received.
● When the unit is on, press the "DISPLAY" key on the remote control, the plenum control
LED display can be turned on and off.
● When the unit is on, press the "LOCK" key on the remote control to prevent operation of
the plenum touch key. Press "LOCK" again to unlock this function.
● When run on heating mode in low ambient temperatures the unit will periodically defrost the
outside coil. The plenum will display "dF" during defrost operation and then return to
heating once the defrost is completed.
When the ambient temperature is lower than 0℃/32℉ , the heating capacity is reduced.
●
●
If the device is left unused for long time, please remove the batteries from the remote
control.
● The air-conditioner features power cut memory and automatic starting-up after power is restored.
key on the plenum. The selected mode will cycle through " OFF ->COOL->FAN
" "
" " , FAN ， HEAT
" "
C
" "
" "
, AUTO .
Note
Tips
15