Functions; Interlock Function; Test Function - Omron F3SP-U2P Instruction Manual

Muting controller

Hide thumbs Also See for F3SP-U2P:

Table of Contents

Section 1 Description

1-2 Functions

The auto reset mode and the manual reset mode are selectable features of the F3SP.

The selection will be done by dip switch (Please refer to Section 4-1 for selection of dip

switch).

[Note]: While the F3SP is connected to power, do not change any dip switch to

1) Auto reset mode

The F3SP automatically starts after power-ON and automatically restarts after the

object in the detection zone is removed.

2) Manual reset mode

Returns to the normal operating mode only after the object has been removed and the

RESET button has been pressed.

1) Self-test

After power ON, the F3SP performs a complete self-test. In addition, it performs a self-

test periodically during operation.

2) External test

This is used to check if the whole system works effectively. By pressing the TEST

(NOTE1)

button

, this simulates the interruption of one or both safety light curtains. This

operation makes the machine stop, so the system checks can be made according to

the established time and modes.

[Note1]: TEST button must be pressed more than 100ms.

3) Error detection and restoration (Lockout condition)

If an error is detected by the self-test the F3SP enters the lockout condition, keeps the

in their OFF-state and displays the error code

Turning the power ON again, or applying the pressing RESET button, resets the

lockout condition.

*1. Refer to Section 7 Status indication codes for the indicating patterns.

avoid influence on the system safety.

(*1)

in status indicator.

Table of Contents