Table of Contents
Advertisement
For your safety, always heed the followings
(1) The procedures of installation and inspection in this manual should be read
carefully.
(2) Loads must satisfy all the conditions below:
•
Is not short-circuited.
•
Is not used with current higher than the rating.
(3) Be sure to dispose of the F3SP as industrial waste.
1.
Muting lamp is required for operation of F3SP, even if you don't use muting
function. Be sure to prepare and install muting lamp. (Please refer to Section
1-3 Ratings and Performance)
2.
Installation Environment
•
Do not install the F3SP in the following environments:
(1) Areas exposed to corrosive gases
(2) Areas exposed to vibration or shock levels higher than
(3) Areas where the F3SP may come in direct contact with water.
(4) In flammable or explosive environments.
•
Do not use radio equipment, such as cellular phones, walkie-talkies,
or transceivers with high power, near the F3SP.
3.
Wiring and Mounting
(1) Be sure to turn OFF the power prior to wiring.
(2) Be sure to route the F3SP cable separate from high-potential power
lines or through an exclusive conduit.
4.
Do not use any solvents such as paint thinners, benzene or acetone to clean
the F3SP because it will dissolve resin and paint.
5.
Do not disassemble, repair, and modify the F3SP. The F3SP does not
contain parts subject to maintenance.
iv
specification provisions.
Notice
Correct Usage
Advertisement
Table of Contents
