Component Replacement Fryer; Front Panel; Front Panel Bezel; Computer Removal - Pitco MGII Service Manual

https://appliancetechmanuals.com
MGII and MG2T GAS FRYER

5. Component Replacement Fryer

5.1. Front Panel

WARNING! SHUT OFF APPLIANCE AND DISCONNECT ALL POWER

5.1.1. Front Panel Bezel

1. Remove Bezel Screws with Phillips Screwdriver.
2. Rotate Bezel forward.
3. Disconnect 12 Position Connector(s) connecting
Computer to Wire Reduction Board Harness.
4. Remove Bezel.
CONNECTIONS PRIOR TO STARTING ANY SERVICE WORK
L22-236 Rev. 2 (06/11)
5.1.2.

Computer Removal

1. Remove two #10-24 nuts securing top of
computer to bezel studs.
2. Loosen two #10-24 nuts securing bottom of
computer to bezel studs.
3. Remove computer from bezel.
5.1.3.

Wire Reduction Board

1. Fuse, F1, is located on Wire Reduction Board.
Replace with 2.5 A Fast acting fuse, if needed.
2. Disconnect all harnesses from Wire Reduction
Board.
3. With a narrow tip flat-blade screwdriver, remove
four wire reduction board-mounting crews. Note:
Retain wire reduction board insulation and
screws for reinstallation.
SERVICE
17