Table of Contents
Advertisement
Record Sequence
Note:
Sequences can only be used to control channels that are patched to DMX, sACN or Art-
Net addresses.
Sequences play back on sequence buttons on pages. A sequence may contain up to 99 steps
with fade and step timing.
Note:
A sequence button must be available on a
Press Record and then the sequence button to begin recording a sequence.
See
Edit Sequence List
Sequence recording is a mode which takes over the screen. The recording mode is shown by a
red surround to the screen.
While in the recording mode you may visit other screens to set parameters. While in those
screens, a red watermark will be displayed showing what step you are editing.
To return to the main recording screen press Record again. You may
made and exit immediately with Store & Exit or you may store the step and remain inside
sequence recording to record further steps with Store & New. Press Cancel to leave the
recording screen without saving anything.
Store And New
The current lighting levels will be stored in the selected
remain open so additional steps can be recorded. Use
mode and resume normal operation.
Store And Exit
The current lighting levels will be stored in the selected
completed. The recording mode is then closed, and normal operation resumes. Use
New
to keep the recording mode open to record additional steps.
Include Options
When recording to a
Recording Your Looks For Playback
for information about editing an existing sequence.
sequence
step, you may specify which lighting channels and sets of
page
before a sequence can be recorded.
store
sequence step
and recording will be
Store And Exit
to close the recording
sequence step
and recording will be
the step you have
Store and
26
Advertisement
Table of Contents
