Application Of Resistance Temperature Detector (Rtd) - East Tester ET-2712 RTD User Manual

5 Application
Temperature Detector (RTD)
Connect the calibrator and the instrument to be tested according to the Figure 5-1.
Simulation of RTD should be based on the following steps:
1. If necessary, press
2. Press
3. Press or
Note: Three-wire (3 W) and four-wire (4 W) terminals are just for measurement, not
output simulation. The calibrator can simulate a two-wire RTD output in the front
panel. To be connected to a three-wire or four-wire transducer, use folding cable to
provide extra wiring.
to select
to select RTD graduation.
to select temperature. Press
of
mode.
or
Sensor terminal of transducer
Figure 5-1
Resistance
to select digit.
13