Auto Ramping The Output; Factory Reset - East Tester ET-2712 RTD User Manual

6.2 Auto Ramping the Output

Auto ramping gives you the ability to continuously apply a varying stimulus from the
calibrator to a transmitter, while your hands remain free to test the response of the
transmitter. When you press
100 % - 0 % ramp in your choice of three ramp waveforms:
The calibrator will produce a continuous, repeated slope output ranging from 0% -
100% -0%when
selection:
0%-100%-0%

0%-100%-0%

0%-100%-0%

Exit the slop output function, please press any key.

6.3 Factory Reset

Factory reset consists of the following default setting:
The working status recovers to the voltage measurement.

Automatic shutdown time is reset to be 30 min, which is effective.

LCD backlight brightness is set to be 60%.

Output range is recovered to be factory default.

Start the calibrator and press
factory default will enter working mode when the recovery is completed.
_
, the calibrator produces a continuously repeating 0 % -
is pressed. Three slope wave shapes are available for your
40-second smooth ramp
15-second smooth ramp
25% stepping ramp. Each step remains 5 seconds.
until the buzzer works and the recovery of
15