Advertisement
Once you are satisfied with the fit and the measurements, apply a few drops
of foam safe CA glue to the joints between the fuselage and the wing just
to hold them in position. Repeat this process for the horizontal stabilizer.
Check the measurements once again to ensure they are correct. If the measurements are
correct for both wing and stabilizer, and these are level to each other, you can then apply
a foam safe glue to all the joints for a permanent bond.
Adjust the elevator so that there is a hinge gap of about 1mm, and that it is
evenly spaced on both sides of the fuselage. Use foam safe CA to glue the
hinges into both the stabilizer and elevator hinge slots.
6
Advertisement
