Advertisement
TROUBLE SHOOTING:
Motors do not run:
1. Battery is not fully charged (charge the battery).
2. Transmitter battery is low (charge or install a fully charged battery).
3. Motors are not connected properly (check the motor to ESC connections and the ESC to battery
connections).
4. Receiver is not bound to the transmitter (consult your radio manual and go through the binding
procedure).
5. ESC is in set-up mode (hold model and move throttle up to full then back to idle, or reverse the
throttle channel on your transmitter. Switch everything off before doing this).
Model moves backwards:
1. Propeller fitted on backwards (swap the propeller around).
Control surfaces not moving with stick input:
1. The servo leads are not connected properly (check the servo connections).
2. The servo is damaged (replace the servo).
The model does not fly straight:
1. Control surfaces are not at neutral (adjust the trims/sub trim on your transmitter).
2. C of G is not correct (re-position the battery to achieve correct balance).
3. Model does not climb well:
1. The battery is not fully charged (charge the battery).
2. The elevator servo is reversed (change the direction via your transmitter settings).
3. C of G to far forwards making it nose heavy (move battery backwards or add weight to tail).
17
Advertisement
