Advertisement
®
CAM LOCK NOTE:
If cam lock is installed high on the
surface, tap it down flush with the
surface. If that doesn't work,
replace part.
If cam lock is installed low into
the surface, screw cam pin out
to extend the length of the
cam pin.
CAM LOCK
(See cam lock note)
Align end
panel cam
locks with
this edge
Make sure the cam
lock is located parallel
to the side of the
surface as shown
in step 3a.
Apply stickers on all visible
cam joint faces to cover the
connector faces, after assembly.
Shorter offset side
NOTE: The cam pin is
offset and needs to be
installed on the shorter
PANEL
offset side. If the screw
heads are not visible,
CAM PIN
o
turn the panel 180
.
CAM LOCK
3a
Cam Lock Fastening
(The cam lock screw needs to
be turned 3/4 full turn or 270
complete engagement.)
5
IMPORTANT: The assembly must be attached to an adjacent unit.
Refer to assembly direction 158275 to attach to a Bridge,
or 158276 to attach to a Return.
Align modesty
panel cam
locks with
this edge
o
for
4
3b
Pilot hole
Page 3 of 3
locations
Doc # 159428 Rev A
Advertisement
