Steelcase Currency Enhanced Wall Mounted Organizer and Open Shelf Assembly Directions

Wall mounted organizer and open shelf

Download this manual

Failure to properly secure cabinet could result in

personal injury. Be sure to install ALL fasteners

as prescribed.

If you have a problem, question, or request, call

your local dealer, or Steelcase Line 1 at

888.STEELCASE (888.783.3522)

for immediate action by people who want to help you.

(Outside the U.S.A., Canada, Mexico, Puerto Rico,

and the U.S. Virgin Islands, call: 1.616.247.2500)

Or visit our website: www.steelcase.com

2021 Steelcase Inc.

Grand Rapids, MI 49501

U.S.A.

Printed in U.S.A.

Currency

Enhanced -

CRUSH HAZARD

Wall Mounted Organizer and Open Shelf

WARNING

Read the entire Assembly Direction for your product mounting configuration

before beginning installation. Obtain assembly directions for

and Open Shelf

from your local Steelcase dealer or by calling 1-888-783-3522.

60" Organizer

(shown in this direction)

Wall Mounted Organizer

48" Open Shelf

Page 1 of 4

Doc # 158171 Rev A

Need help?

Do you have a question about the Currency Enhanced Wall Mounted Organizer and Open Shelf and is the answer not in the manual?

Page 1 Wall Mounted Organizer before beginning installation. Obtain assembly directions for personal injury. Be sure to install ALL fasteners and Open Shelf from your local Steelcase dealer or by calling 1-888-783-3522. as prescribed. 60" Organizer (shown in this direction) 48" Open Shelf...
Page 2 ® MINIMUM # OF UNIT SIZE STUDS TO BE USED 30" 36" 42" 48" INSTALL HANGER CLEAT TO THE WALL 54" 60" Determine desired height of unit from the floor. 66" NOTE: If a tackboard is to be used, be sure to 72"...
Page 3 ® Install shoulder screws into rear panel of organizer (there may be one or three depending on size of unit). Carefully lift the organizer into position above the hanger cleat so that the shoulder screw(s) are aligned with modeez fastener(s) in the cleat, then lower into place as shown.
Page 4 ® Secure each end with a machine screw as shown. Secure each end with a machine screw as shown. Locate and drill through holes in the back panel of Organizer. Locate and drill through holes in the back panel of Organizer. Repeat for approximately every 20"...