Advertisement
®
WARNING
TIP OVER
HAZARD
DO NOT:
Pull down on doors (if equipped)
Move unit or adjust glides if loaded
You MUST:
Install this unit against a wall or gang
to a similar unit.
See Assembly Directions for further
instruction, available from Steelcase
dealer or call 1-888-783-3522
FOLLOW THESE INSTRUCTIONS TO
PREVENT UNIT FROM TIPPING OVER AND
CAUSING INJURY.
WARNING: TIP OVER HAZARD
12" wide towers must be attached to a wall,
under worksurface storage or an end panel.
DO NOT:
pull down on doors
move unit while loaded
move unit by lifting from its top
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©
2021 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Curency
®
Enhanced - Towers, Counterweights,
Glide Leveling and Shelf Adjustment
Page 1 of 4
Doc # 158170 Rev A
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Steelcase Curency Enhanced Towers
Summary of Contents for Steelcase Curency Enhanced Towers
- Page 1 If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you.
- Page 2 ® Leveling a Cabinet with Drawers Unlock (1a) and remove bottom drawer (1b). Adjust leveling glides. To remove drawers push lever down on one side, and up on the other. Leveling a Cabinet without Drawers Adjust leveling glides. Page 2 of 4 Doc # 158170 Rev A...
- Page 3 ® Hinge Adjustment Adjustable Shelf Installation Adjust doors. A #2 screwdriver is Install (4) shelf pins per shelf in desired recommended for adjusting hinge. location as shown. UP/DOWN Lower each shelf into place. DOOR HINGE IN/OUT SIDE TO SIDE Page 3 of 4 Doc # 158170 Rev A...
- Page 4 ® For style # CRTW (Single Door above Drawers) Two (2) counterweights are required. Install both counterweights on top of each other, behind the drawers, using four (4) #10 x 2" flat head screws through the holes provided. Page 4 of 4 Doc # 158170 Rev A...
Need help?
Do you have a question about the Curency Enhanced Towers and is the answer not in the manual?
Questions and answers