7.7 CHANGING AN IDENTIFICATION NUMBER
•
To change the ID number a cooler MUST BE powered and configured individually.
•
So, turn OFF the power to all the other coolers and heaters on the Network System�
Use the Installer Set-Up program as follows�
•
Turn the Brivis Networker OFF�
•
Press (clock) Key 5 and the screen will display the message "Clock setting mode". After the message has
finished ensure that the time is flashing.
•
Now simultaneously press and hold the 2nd & 4th keys for 3-5 seconds until the message displays "Installer
parameter access". After the message has finished the display will appear like this. If a Heater is also on the
system you will need to press the Mode button�
Parameter Number
Brivis Advance, Brivis Promina & Brivis Contour Models Only:
EO1 IDO7:
Cooler
Parameter
Number
Number
•
Rotate the rotary dial to change the parameter value displayed at the top right of screen to the unit number
required for this Cooler (as shown below by unit number " 2").
•
Wait one minute before proceeding to allow for the programming change�
Parameter Number
Brivis Advance, Brivis Promina & Brivis Contour Models Only:
EO1 IDO7:
Cooler
Parameter
Number
Number
•
Press the Brivis Networker ON/OFF button to exit the program�
•
Turn the power supply at the Cooler OFF to save the new ID number�
•
Repeat the sequence for each Cooler�
•
Then follow the Brivis Networker Advanced Programming Instructions to allocate the Coolers to their respective
zones�
Brivis
E0 1 ID07: 1
Cooler Number
Parameter Value
1
Parameter
Value
E0 1 ID07: 2
Cooler Number
Parameter Value
2
Parameter
Value
7. NETWORK CONNECTION
On/Off Button
Keys 2 and 4
Key 5 (Clock)
Rotary Dial
Brivis AD Models Only:
EO1 IDO9:
Cooler
Parameter
Number
Number
On/Off Button
Keys 2 and 4
Key 5 (Clock)
Rotary Dial
Brivis AD Models Only:
EO1 IDO9:
Cooler
Parameter
Number
Number
17
1
Parameter
Value
2
Parameter
Value
Evap AC IM