Before The First Use; Using The Weather Station - Vitek VT-6408 Manual Instruction

ENGLISH
•
•
THE UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY, ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK
SPACES IS PROHIBITED.

BEFORE THE FIRST USE

After unit transportation or storage under
cold (winter) conditions, it is necessary
to keep it for at least three hours at room
temperature.
– Unpack the unit completely and remove
– Check the unit for damages; do not use it

USING THE WEATHER STATION

External sensor (15)
– Open the battery compartment lid (20)
– Press the button (19) to select the tem-
– You can hang the external sensor (15)
M VT-6408.indd 4
malfunction is detected or after it was
dropped, unplug the unit and apply to any
authorized service center at the contact
addresses given in the warranty certificate
and on the website www.vitek.ru.
To avoid damages, transport the unit in the
original package only.
Keep the unit in a dry cool place out of
reach of children and disabled persons.
any package materials and advertising
stickers that prevent the unit operation.
in case of damages.
and install two "AAA" batteries (not sup-
plied) in to the battery compartment (18),
strictly following the polarity, the display
(16) will show the digital temperature indi-
cations measured by the wired sensor (17)
and the symbols of the data transfer chan-
nel "CH1".
perature measurement units «°С/°F», the
temperature will be shown on the display
(16) in the preset measurement units «°С
or°F», place the lid (20) back to its place.
by the hanging place (20) or set it on the
base (22). Direct the sensor (15) to the
main unit (1).
– Place the sensor (15) in such manner to
avoid getting it exposed to moisture and
direct sunlight.
– Do not install the external sensor (15) in
places with the temperature below 0°С, it
may lead to shorter service life of the bat-
teries, shorter data transmission range
and display (16) indication problems.
– Install the external sensor (15) in the room
and place the wired sensor (17) outside.
– Do not install the external sensor (15) in
more than 30 meters from the main unit (1).
– Select such location of the external sen-
sor (15) to reduce the number of obsta-
cles for the radio signal from the external
sensor (15) to the main unit (1), such as
doors, walls or furniture, do not place the
sensor (15) near metal items and electric
appliances.
– For the best data receipt quality of the
main unit (1) try different positions of the
main unit (1) or the external sensor (15).
Note: - interference from professional or
household electrical appliances such as
doorbells, home security / alarm systems,
incoming control systems, radiotelephones,
walkie-talkies, games, computers and other
sources of interference may lead to tempo-
rary or permanent disturbances in receiv-
ing signals by the main unit (1) , this does
not affect the main technical characteristics
of the unit, in some cases, the main unit (1)
or the external sensor (15) should be moved
to another location, free from the above said
or other obstacles preventing the passage
of signals from the sensor (15).
Main unit (1)
– Remove the battery compartment lid (13)
and insert 2 "AAA" batteries (not supplied
with the unit) strictly following the polarity,
install the lid (13) back to its place.
– Digital indications of ambient temperature
(2) will be appear on the display.
– After the batteries are installed, the main
unit (1) is mated to the external sensor
(15), and the reception indicator symbols
4
20.02.2018 9:26:21