Options" Function - VWR avantor 710-2088 Instruction Manual

"OPTIONS" function

In this programme the following SUB-MENUS are listed: Edit Volumes, Edit Multi-
Cycles, Edit Sites, Edit Operators, Display Records, Store PDF, Store XML, Clear Record,
Set Time, Set Autoswitch, Password Admin, Password PDF, Language, Store Config
and Load Config.
Switch on the unit by pressing the OK button for at least two seconds.
Select OPTIONS function by pressing the "UP" or "DOWN" arrows.
Press OK to enter the sub menu.
"EDIT VOLUMES" function (modification of the value of a stored volume)
Using this procedure, it is possible to memorise up to eight different volumes (from 1 to
1999 litres of air).
Switch the unit on by touching the OK button for at least two seconds.
Select OPTIONS by pressing the "UP" or "DOWN" arrows
Select the EDIT VOLUMES function by pressing the "UP" or "DOWN" arrows.
Press OK to modify the volumes.
Select a volume by pressing the "UP" or "DOWN" arrows and press OK. Select a function
(ADD?, EDIT?, or DELETE?) by pressing the "UP" or "DOWN" arrows and press OK.
Change the digit indicated (flashing) by pressing the "UP" or "DOWN" arrows and presses
OK to go to the next figure.
Repeat until you reach the last digit and then confirm by pressing OK.
Note: It is always possible to edit an entry (change the values), if the total number of
entries is below 20 you can add a new entry, otherwise the ADD? option not shown. You
can delete entries as long as there are at least 2, otherwise the DELETE? option is not
shown. The maximum air volume is 2000 litres.
Instruction manual | vwr.com 15