Using The Vacuum Cleaner - BRAYER BR4262 Instruction Manual

• Before using the unit for the first time or after a long
period of inactivity, charge the battery.
• Hang the vacuum cleaner using the recess in the
vacuum cleaner body (14) onto the wall-mounted
holder (22).
• Connect the power adapter (20) to the mains socket,
the indicator (7) will light up and start flashing. When
the battery is fully charged, the indicator (7) will glow
constantly.
• Full charging of the rechargeable battery takes about
4-5 hours.
• After charging the battery disconnect the power
adapter (20) from the mains.
Notes:
– charge the battery at the temperature from +5°C to
+35°C.
– if you didn't use the vacuum cleaner for more than
2-3 months, fully charge the battery before using the
vacuum cleaner.

USING THE VACUUM CLEANER

ATTENTION!
– If the suction power of the vacuum cleaner decreases
rapidly while cleaning, switch it off immediately and
check the extension pipe (4) for obstruction. Remove
the obstruction and only then continue cleaning.
– Do not use the vacuum cleaner to collect burning or
smoking cigarettes, cinders, plaster or concrete dust,
flour or ashes.
– The vacuum cleaner is not intended for collecting
water or other liquids.
– Do not use the vacuum cleaner in places where
aerosols are used or sprayed, and in proximity to highly
inflammable liquids, do not use the vacuum cleaner in
the places where such liquids are stored.
SWITCHING THE VACUUM CLEANER ON
Attention! Switch the vacuum cleaner on only with
the dust bin (13) installed and with the separator
(18) and the filter block (19) installed in the dust bin.
• During cleaning or when carrying the vacuum cleaner
hold the unit by the handle (10).
• For easy storing of the vacuum cleaner or the battery
charging use the wall-mounted holder of the vacuum
cleaner (22).
• To switch the vacuum cleaner on press the on/off
button (9). The vacuum cleaner will switch on at the
low power level. To switch the maximal power on,
press the button (8) and press the button (9) again to
switch the vacuum cleaner off.
• During the vacuum cleaner operation the indicators
(7) light up and electric brush (1).
• When the last indicator (7) starts flashing, switch the
vacuum cleaner off and charge the battery.
EN 9