Battery Charging - BRAYER BR4262 Instruction Manual

8 EN
• To detach the extension pipe (4) from the vacuum
cleaner press and hold the clamp (5).
• To detach the electric brush (2) from the extension
pipe (4) press and hold the clamp (3).
Electric brush
• Use the electric brush (2) for cleaning rooms with
smooth floors or carpets with medium and low pile.
Notes:
– do not use the electric brush (2) if the pile length
exceeds 15 mm.
– do not run the electric brush (2) over electric wires.
– after you finish cleaning the room with the electric
brush (2), switch the vacuum cleaner off with the on/off
button (9).
Сrevice nozzle
• The crevice nozzle (23) is intended for cleaning
radiators, crevices, etc. and for collecting dust
from furniture surface; pile prevents the damage of
polished furniture surface. While cleaning set the
brush to the required position (pic. 2).
• You can attach the crevice nozzle (23) to the
extension pipe (4) or to the air inlet of the vacuum
cleaner (pic. 3).
WALL-MOUNTED HOLDER OF THE VACUUM
CLEANER
• Select the storage place for the vacuum cleaner/the
battery charging. Place the wall-mounted holder (22)
near the mains socket.
• Place the wall-mounted holder (22) so that the
vacuum cleaner does not hang. The vacuum cleaner
should rest on the electric brush (2) (pic. 4).
• Remove the plug from the wall-mounted holder (22)
(pic. 5).
• Insert the power adapter connecting cord jack (21)
(pic. 6).
• Install the plug back to its place (pic. 6).
• Fasten the wall-mounted holder (22) with dowels and
fastening screws.

BATTERY CHARGING

ATTENTION!
– Use only the battery supplied with the unit. Using a
non-original battery can be dangerous.
– Do not expose Li-ion batteries to impacts and high
temperatures. Do not disassemble the battery to avoid
the electrolyte leakage.
– Do not throw the battery into fire.
– Avoid the battery terminals circuit, it may cause burns
or fire.
– Do not discard the battery with usual household
waste, apply to a specialized center for further recycling.