BRAYER BR4262 Instruction Manual page 7

nit. • For children safety reasons do not leave polyethylene
bags used as a packaging unattended.
er
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
es
suffocation!
s
• The unit is not intended for usage by children.
able
• Do not leave children unattended to prevent using
ere
the unit as a toy.
• Do not allow children to touch the power adapter
or
body during battery charging.
• Be especially careful if children or disabled persons
are near the operating unit.
• During the unit operation and breaks between
operation cycles, place the unit out of reach of
children.
• The unit is not intended for usage by physically or
mentally disabled persons (including children) or by
persons lacking experience or knowledge if they are
not under supervision of a person who is responsible
for their safety or if they are not instructed by this
person on the usage of the unit.
er
• Do not repair the unit by yourself. Do not
ner
disassemble the unit by yourself; if any malfunction is
detected, and after the unit has been dropped, apply
to the service center.
• To avoid damage, transport the unit in the original
m
package.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After the unit's transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
• Unpack the vacuum cleaner, remove all packaging
and advertising materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages; if the unit is damaged,
do not switch it on.
• Make sure that specified specifications of power
supply voltage of the power adapter correspond to
the specifications of your mains.
ASSEMBLING THE VACUUM CLEANER (Pic. 1)
• Install the rechargeable battery (12) to the installation
place until the lock (11) clicking.
Attaching the extension pipe
• Insert the extension pipe (4) into the vacuum cleaner
air inlet untilthe clamp (5) clicking.
• Connect the electric brush (2) to the extension pipe
(4).
EN 7