Using The Vacuum Cleaner; Assembling The Vacuum Cleaner - BRAYER BR4260 Instruction Manual

8 EN
– If you detect any bulgings of the battery body, stop
using the battery immediately.
– Avoid the battery terminals circuit, it may cause burns
or fire.
– Do not discard the battery with usual household
waste, apply to a specialized center for further recycling.
• Install the battery (10) to the installation place until
the lock (9) clicking.
• Before using the unit for the first time or after a long
period of inactivity, charge the battery (10).
• Install the base (1) in a convenient place near a
mains socket.
• Install the vacuum cleaner on the base (1).
• Insert the power adapter (22) connection cord jack
(23) into the socket (8).
• Plug the power adapter (22) into the mains socket,
the indicators (5) will light up.
• The battery (10) charging level is shown with the
indicators (5).
• Full charging of the battery (10) takes about 4 hours;
the indicators (5) will be flashing. When the battery
(10) is fully charged, the indicators (5) will glow
constantly.
• When the battery (10) is fully charged, the indicators
(5) will go out after 3 minutes. Then unplug the power
adapter (22).
• Remove the power adapter (22) connection cord jack
(23) from the socket (8).
Notes:
– charge the battery (10) at the temperature from +5°C
to +35°C.
– if you didn't use the vacuum cleaner for more than 2-3
months, fully charge the battery (10) before using the
vacuum cleaner.

USING THE VACUUM CLEANER

ATTENTION!
– If the suction power of the vacuum cleaner decreases
rapidly while cleaning, switch it off immediately and
check the extension pipe (12) for obstruction. Remove
the obstruction and only then continue cleaning.
– Do not use the vacuum cleaner to collect burning or
smoking cigarettes, cinders, plaster or concrete dust,
flour or ashes.
– The vacuum cleaner is not intended for collecting
water or other liquids.
– Do not use the vacuum cleaner in places where
aerosols are used or sprayed, and in proximity to highly
inflammable liquids, do not use the vacuum cleaner in
the places where such liquids are stored.

ASSEMBLING THE VACUUM CLEANER

Attaching the extension pipe and attachments
• Insert the extension pipe (12) into the vacuum
cleaner air inlet until the clamp (11) clicking (pic. 1).