BRAYER BR4260 Instruction Manual page 9

• Choose the necessary attachment – the electric
brush (15), the crevice nozzle (13) or the small brush
(17) – and attach it to the extension pipe (12) (pic. 2).
Note: if necessary, you can attach the crevice nozzle
(13) or the small brush (17) straight to the air inlet of the
vacuum cleaner, without using the extension pipe (12).
• To detach the extension pipe (12) from the vacuum
cleaner press and hold the release button (11). To
remove the attachments (13, 15, 17) press and hold
the release button (14).
Electric brush
• Use the electric brush (15) for cleaning rooms with
smooth floors or carpets with medium and low pile.
Notes:
– do not use the electric brush (15) if the pile length
exceeds 15 mm.
– do not run the electric brush (15) over electric wires.
– after you finish cleaning the room with the electric
brush (15), switch the vacuum cleaner off with the on/
off button (6).
Crevice nozzle
• The crevice nozzle (13) is intended for cleaning
radiators, crevices etc. (pic. 3)
• You can attach the crevice nozzle (13) to the
extension pipe (12) or to the air inlet of the vacuum
cleaner.
Small brush
• Use the small brush (17) for collecting dust from
smooth furniture surface, the pile prevents the
damage of polished furniture surface.
• You can attach the small brush (17) to the extension
pipe (12) (pic. 4) or to the air inlet of the vacuum
cleaner (pic. 5).
SWITCHING THE VACUUM CLEANER ON
Attention! Switch the vacuum cleaner on only with
the dust bin installed and with the separator (18)
and the filter block (19) installed in the dust bin.
• During cleaning or when carrying the vacuum cleaner
hold the unit by the handle (7).
• For easy storing of the vacuum cleaner or the battery
charging (10) use the base (1).
• To switch the vacuum cleaner on press the on/off/
power selection button (6), the vacuum cleaner
will switch on at low power level. Press the button
(6) again to switch the vacuum cleaner on at the
maximal power. Press the button (6) again to switch
the vacuum cleaner off.
• During the vacuum cleaner operation the indicators
(5) light up and show the charge level of the battery
(10). As the battery runs low, the number of glowind
indicators (5) decreases.
• When the last indicator (5) starts flashing, switch the
vacuum cleaner off and charge the battery (10).
EN 9