Prochem EVEREST LP Operating Instructions Manual page 30

Vacuum Exhaust Heat Exchanger
Pulley Set Screws & Hub Cap
Screws, Water Pump Clutch Shaft
Chemical Pump & Check Valves
Check Valve (Solution Outlet)
Vacuum Pump
Nitrogen Accumulator
Waste Tank Filters/Strainers
* Or as often as required
** Change water pump crankcase oil after the first 50 hours
***Change engine crankcase oil and filter after the first 50 hours
****Perform drive belt, pulley and hub maintenance after the first 25 hours of operation, and then again at
100 hours
*****If using AEON PD synthetic lubricant, 4500 hours or every 2 years, whichever comes first
500 hrs
500 hrs
Water Pump
500 hrs
Bolts
Drive Pulley 500 hrs
Drive Pulley 500 hrs
Drive Belts 500 hrs
Drive Belts 500 hrs
Engine 500 hrs
Governor 500 hrs
500 hrs
Heater Core 500 hrs
Engine 1000 hrs
1000 hrs
1500 hrs
Engine Yearly
Engine Yearly*
Yearly*
Engine
Yearly*
Yearly
Engine 2 years
Engine 3 years
EVEREST 980086 05/05/04
Inspect cores and remove debris.
Change oil**
Check for proper torque valves. Re-torque, if
required****
Inspect, clean and check for pulley groove wear****
Check pulley alignment****
Inspect and clean****
Check belt tension****
Drain and refill engine governor oil.
Drain and refill.
Replace diaphragm and check valves.
Clean and inspect.
Replace spark plugs.
Inspect, clean, and repair, if needed.
Drain, flush, and replace oil *****
Flush radiator and change engine coolant.
Replace in-line fuel filter on engine.
Replace air cleaner element.
Replace Accumulator.
Check for damage and blockage. Replace if needed.
Replace radiator hoses and hose clamps.
Replace ignition wires.
MAINTENANCE
SERVICE SCHEDULE
4-2