Long-Time Recording (Mdlp) - Sony MZ-N10 Operating Instructions Manual

7
Play the source you want to record.
The recorder stars recording
automatically when it receives the
playing sound.
To stop recording
Press x.
z
When there is no sound from the player for
about 3 seconds during synchro-recording, the
recorder goes into the standby mode
automatically. When the sound comes from the
player again, the recorder resumes synchro-
recording. If the recorder is kept in the standby
mode for 5 minutes or longer, the recorder stops
automatically.
Notes
• The pause function cannot be turned on or off
manually during synchro-recording.
• Do not switch the "SYNC REC" setting while
recording. Recording may not be done
properly.
• Even when there is no sound on the sound
source, there may be cases when recording
does not pause automatically during synchro-
recording due to the noise level emitted from
the sound source.
• If a silent portion is encountered for
approximately 2 seconds during synchro-
recording from a sound source other than a
CD or an MD, a new track mark is
automatically added at the point where the
silent portion ends.
30
Long-time recording
(MDLP)
Select each recording mode according to
the recording time that you want.
Stereo recording is possible at 2 times
(LP2) or 4 times (LP4) the normal
(stereo) recording time. Monaural
recording at 2 times normal recording
time is also possible.
MDs recorded in MDLP mode can
be played back only on MD players
or recorders with MDLP playback
mode.
zREC
Jog dial
1
While the recorder is stopped, press
the jog dial.
2
Turn the dial until "REC SET"
appears in the display, and then press
the jog dial.
3
Turn the dial until "REC MODE"
appears in the display, and then press
the jog dial.
4
Turn the jog dial to select the desired
recording mode, and then press the
jog dial to enter the selection.
Recording Display
1)
mode window
on the
recorder
SP stereo SP
LP2 stereo LP2
LP4 stereo LP4
Recording
3)
time
Approx. 80
min.
Approx. 160
min.
Approx. 320
min.