Sony MZ-N10 Operating Instructions Manual page 24

To
Record from the end of the
current contents
Record over previous
material from a point
partway through
Pause
Remove the MD
1)
If "REC-Posi" is set to "From End", recording operations will always start from the end of the
previously recorded material without pressing the END SEARCH button (page 63).
2)
A track mark is added at the point where you press
the remainder of the track will be counted as a new track.
3)
If you open the lid while "REC-Posi" is set to "From Here", recording will begin from the top of the
disc the next time you record. Check the point to start recording on the display.
If the recording does not start
• Make sure the recorder is not locked (pages
15, 20).
• Make sure the MD is not record-protected
(pages 22, 79).
• Premastered MDs cannot be recorded over.
24
Press
Press END SEARCH, and then press and slide zREC.
1)
Press N, or press the 5-way control key towards ., or
> to find the start point of recording, and then press x to
1) stop. Then press and slide zREC.
Press X
Press X again to resume recording.
Press x and open the lid.
"TOC Edit" flashing in the display.)
2)
.
3)
(The lid does not open while
X
again to resume recording while pausing; thus
To know the recording
condition
The REC LED lights up or flashes
according to the recording condition.
Recording
condition
While recording
Recording standby
Less than 3
minutes' recording
time available
A track mark has
been added
While checking-out flashes faster
1) Except when track marking was done
manually or automatically using Auto Time
Mark (page 33).
REC LED
lights up
flashes according
to the loudness of
the source while
recording with a
microphone
(voice mirror)
flashes
flashes slowly
goes off
1)
momentarily
1)