While Recording - Sony MZ-N10 Operating Instructions Manual

Symptom
The USB cradle and
the recorder become
hot during the
charging procedure.

While recording

Symptom
The recorder
overwrites existing
materials when record.
The recording starts
from the end of the
disc even when "REC-
Posi" is set to "From
Here".
"REC-Posi" (the
record-starting point)
cannot be set to "From
Here".
Recording cannot be
done correctly.
Cause/Solution
• This is normal and poses no danger.
Cause/Remedy
• The record starting-position setting ("REC-Posi") is set to
"From Here".
, Set "REC-Posi" setting to "From End".
• The group recording ("
(You cannot overwrite tracks when "
REC ON".)
, Set the group recording setting to "
(page 63).
• The group recording ("
, Set the group recording setting to "
(page 63), and then set "REC-Posi" to "From Here".
• Audio sources may not be securely connected.
, Disconnect the audio sources once and connect them again
(pages 23, 29, 31).
• There is no digital signal from the portable CD player.
, When recording digitally from a portable CD player, use
the AC power adaptor and disable the anti-skip function
(such as ESP) on the CD player (page 25).
• The analog recording was made using a connecting cord with
an attenuator.
, Use a connecting cord without an attenuator.
• Recording level is too small to record (when adjusting the
recording level manually).
, Pause the recorder and adjust the recording level (page 34).
• The power sources was disconnected or a power outage
occurred during recording.
, The recording result is not recorded on the disc. Make
recording again.
• The premastered MD is inserted.
, Replace to the recordable MD.
• The remaining recordable time on the disc is 12 seconds or less
("DISC FULL" appears).
, Replace the disc.
: REC") is set to "
: REC" is set to "
: REC OFF"
: REC") is set to "
: REC OFF"
: REC ON".
:
: REC ON".
83