Erasing A Track Mark; Adding A Track Mark - Sony MZ-N1 Operating Instructions Manual

Changing the order of a group
on a disc (Group move)
See the illustrations on Japanese text (page 60).
On the recorder
1 Press GROUP for 2 seconds or more.
2 While playing a track within a group
whose order you want to change, press
the jog dial.
3 Turn the jog dial until "EDIT" flashes in
the display, and then press to enter.
4 Turn the jog dial until "
in the display, and then press to enter.
5 Turn the jog dial to select the destination
point on the disc, and then press to enter.
On the remote control
1 Follow the procedure of "To activate the
group mode" (page 102) to turn the
group mode on.
2 While playing a track within a group
whose order you want to change, press
DISPLAY for 2 seconds or more.
3 Turn the control repeatedly until "EDIT"
flashes in the display, and then press x
to enter.
4 Turn the control repeatedly until
"Group Move" appears in the display
and then press x to enter.
5 Turn the control repeatedly to select a
destination point on the disc, and then
press x to enter.
To cancel moving
Press CANCEL on the recorder.
Press DISPLAY for 2 seconds or more on the
remote control.

Adding a track mark

See the illustrations in Japanese text (page 61).
You can add a track mark so that the part
after the new track mark is counted as new
track. You cannot add a track mark on a
track that has been checked-out from your
computer.
1 While playing or pausing an MD, press
T MARK on the recorder at the point
you want to mark.
"MARK ON" appears in the display,
and the track mark is added.
: Move" flashes
To add track marks while
recording (except while synchro-
recording)
Press T MARK at the point you want to
add a track mark. You can use Auto Time
Stamp to add track marks automatically at
specified intervals (except while digital
recording).

Erasing a track mark

See the illustrations in Japanese text (page 62).
When you record with analog (line) input,
unnecessary track marks may be recorded
where recording level is low. You can erase
a track mark to combine the tracks before
and after the track mark. You cannot erase
a track mark on a track that has been
checked-out from your computer.
1 While playing the track with the track
mark you want to erase, flip the bar
towards X to pause.
2 Find the track mark by pressing .
slightly.
"MARK" appears in the display for 2
seconds.
3 Press T MARK to erase the mark.
"MARK OFF" appears in the display.
The track mark is erased and the two
tracks are combined.
To cancel moving
Press CANCEL on the recorder.
Press DISPLAY for 2 seconds or more on the
remote control.
Notes
• When you erase a track mark between the
two consecutive tracks that are registered
into different groups, the second track is re-
registered into the group containing the first
track. In addition, if you combine a track
that is registered to a group with a track that
is not registered to a group (two consecutive
tracks), the second track takes the same
registration setting as the first track.
However, when the group function is on,
you can only combine tracks within the
selected group.
• You cannot erase track marks according to
the system limitations.
117