Using The Group Function - Sony MZ-N1 Operating Instructions Manual

3 Turn the jog dial until "CLOCK SET"
flashes in the display, and then press to
enter.
The digits of the year flash.
4 Change the current year by turning the
jog dial and press to enter.
The digit of the month flashes.
5 Repeat steps 4 to enter the current
month, date, hour, and minute.
When you press the jog dial to enter the
minute, the clock starts operating.
To display the current time
On the recorder
1 When the recorder is not operating or
while recording, press the jog dial.
2 Turn the dial until "DISPLAY" appears
in the display, and then press to enter.
3 Turn the jog dial until "Clock" flashes in
the display, and then press to enter. The
current time appears in the display.
On the remote control
1 Press DISPLAY repeatedly until current
time appears in the display.
If you make a mistake while setting the
clock
Press . to go back wrongly entered
item, and then enter the correct value. You
can skip a step by pressing >.
To display the time in the 24-hour
system
Press T MARK while setting the clock. To
change the clock to the 12-hour system,
press T MARK again.
To maintain the correct time
Once you set the clock, it will keep correct
time as long as the recorder is connected to a
power source, such as the rechargeable
battery, alkaline dry battery, or AC power
adaptor. However, if no power source is
connected, the clock setting will change back
to the factory setting after about 3 minutes.
When changing the rechargeable battery or
alkaline dry battery, make sure to do it within
3 minutes.
Notes
• Make sure the time is correctly set if you want
the time stamp to be accurately recorded for
an important recording.
• Under normal conditions, the clock may vary
by about plus or minus 2 minutes per month.
BVarious ways of
playback
Searching for a specific track
or a position quickly (Quick
Search)
See the illustration in Japanese text (page 38).
You can do two kinds of quick search.
• Index search — Searching quickly while
monitoring the track numbers or track
names.
• Time search — Searching quickly while
monitoring the elapsed time.
Selecting the search mode
The search mode can be selected only on
the remote control while the recorder is
stopped, playing, or play-paused.
1 Press DISPLAY for 2 seconds or more.
2 Turn the control repeatedly until
"SEARCH" flashes in the display, and
then press x to enter.
3 Turn the control repeatedly until
"Index"(index search) or "Time"(time
search) flashes in the display, and then
press x to enter.
The recorder is factory set to "Index".
4 Press X while playing a disc.
5 Tun and hold the control repeatedly
until the desired track number or track
name appears in the display.
6 Press X to cancel the pause.
Playback starts from the selected track.

Using the group function

See the illustrations in Japanese text (pages 38
to 40 ).
The recorder can operate various playback
with a disc which has group setting.
Listening to tracks in a specific
group (Group Mode Playback)
• Insert a disc with group settings.
On the recorder
1 Start playback.
105
Continued