Sony MZ-N1 Operating Instructions Manual page 112

On the remote control
1 Insert a disc and do the following.
See step 1 of "On the recorder" to check
the varieties of name you can relabel.
2 Follow steps 2 to 4 of "On the remote
control" (page 111) in "Labeling
recordings" to display a track, group, or
disc name
3 Follow steps 5 to 7 of "On the remote
control" (page 111) in "Labeling
recordings", and then keep pressing the
x for 2 seconds or more.
To cancel labeling
Press CANCEL on the recorder.
Press DISPLAY for 2 seconds or more on the
remote control.
Notes
• Track and disc titles that were entered in
Japanese katakana characters will appear in
Roman letters on minidisc players that do
not support the display of katakana
characters. Such titles will be marked with a
"^" at the beginning and the end.
• You cannot relabel premastered MDs or
label MDs that have not been recorded.
• The recorder cannot rewrite a track, group,
or disc name of more than 200 letters that
was created by another device.
Storing phrases frequently
used in labeling
See the illustrations in Japanese text (page 52).
Phrases that you often use while labeling
can be stored in the recorder's memory.
Approximately 25 phrases of about 10
characters each (with a total character
count of about 400) can be stored in the
phrase bank. The actual number will
depend on the length of each phrases.
Storing phrases while labeling a
track or disc
You can store phrases in three ways.
• Storing phrases while labeling a
track, group, or disc:
You can store phrases while labeling a
track, group, or disc by doing the
procedure "Labeling recordings" (page
110).
112
• Storing phrases from a previously
labeled track, group, or disc:
You can store an existing track, group,
or disc name as a phrase.
• Inputting and storing phrases:
You can store frequently used phrases in
advance, and then retrieve and use them
when labeling a track, group, or disc.
Storing phrases while labeling a
track or disc
On the recorder
1 Follow steps 1 to 7 of "Labeling
recordings" (page 110) to enter a phrase.
2 After entering the phrase, press
CANCEL to remove the cursor from the
character palette to the letter input area.
3 Press END SEARCH for 2 seconds or
more.
"Entry!" appears in the display and the
cursor flashes after the phrase you just
stored.
4 If you continue labeling operation, do
steps 5 to 7 of "Labeling recordings"
(page 110).
On the remote control
1 Follow steps 1 to 6 of "On the remote
control" (page 111) in "Labeling
recordings" to enter a phrase.
2 After entering the phrase, press X for 2
seconds or more.
3 If you continue labeling operation, do
steps 5 to 6 of "On the remote control"
(page 111) in "Labeling recordings".
Storing phrases from a previously
labeled track, group, or disc
On the recorder
1 Follow steps 1 and 2 of "Relabeling
recordings" (page 110) and display the
track, group, or disc name that contains
the phrase that you want to store.
2 Press ./> repeatedly to move the
cursor to the right of the phrase.
3 Press END SEARCH for 2 seconds or
more to store the phrase.