Table of Contents
Advertisement
Problem 3: The printhead height adjustment lever is at the down position.
Solution:
Problem 4: You are printing on thick paper or paper that buckles easily.
Solution:
Edges Smeared with Ink
Problem 1: The selected Media Type is not correct for the media loaded in the paper
Solution:
Problem 2: Print media is curled or creased.
Solution:
Problem 3: The cutting dust reduction function is switched on.
Solution:
Black Streaks Visible
Problem 1: Printhead is out of alignment.
Solution:
Problem 2: Printing is not proceeding smoothly due to an interruption in the flow of
Solution:
Fine horizontal lines appear in images printed on backlight film or
synthetic paper.
Problem 1: Standard is selected for Print Quality.
Solution:
7-10
Troubleshooting
Set the printhead height adjustment lever to the center position for normal
printing. (Æ P.2-27)
Make sure that the print height adjustment lever is set to the up position.
(Æ P.2-27)
supply source.
Confirm the current selection for the Media Type. If the setting is not
correct, stop the print job, select the correct setting, then start the print job
again. (Æ P.2-8, P.2-19)
Remove the creasing or curling then start the print job again.
If the cutting dust reduction function is not needed, use the operation panel
to switch off this feature for the print media in use.
Use the operation panel to adjust the amount of feed for the print media in
use. (Æ P.7-38)
data from the computer.
Close other applications that are open and cancel other jobs that are
executing.
In the printer driver, select High or Highest for Print Quality.
Advertisement
Table of Contents
