Table of Contents
Advertisement
Aligning the Printhead
If you notice broken vertical lines or deviation in colors in your prints,
execute Print Pattern A and align the printhead. Before printing a printhead
alignment pattern, make sure A3 size or larger roll media is loaded.
Follow the procedure below to align the printhead.
Note
z When you execute Print Pattern A, use the media most commonly used with the
printer.
z If you are using a cut sheet, make sure at least one sheet of unused A3 paper (not
the blank side of used paper) or larger is set.
1
If the printer is off, press the Power button to switch the printer on.
After a few seconds "Online" is displayed in the operation panel and the
Online lamp lights.
2
Press the Online button twice to display "MAIN MENU".
3
Press
M A I N M E N U
Paper Source
Roll Media
Cut Sheet
Cancel
Paper Source
Roll Media
Cut Sheet
Cancel
or
to select "System Setup" then press
S y s t e m S e t u p
Data
Message
Power
nter
Online
Data
Message
Power
Enter
Online
.
Aligning the Printhead
7-35
Advertisement
Table of Contents
