Mounting The Base Ring; Installing The Table Panels - Pit Boss PB410FP Assembly And Operation Manual

3.

MOUNTING THE BASE RING

Parts Required:
16 x Screw (#A)
Installation:
• Place the assembled Base Ring
overtop of the Fire Bowl and align
on legs, as shown in illustration.
• Mount each Base Ring bracket to
each aligning Leg using four screws.
4.

INSTALLING THE TABLE PANELS

Parts Required:
3 x Table Panel (#8)
1 x Table Panel with Hole (#9)
4 x Table Support Bracket (#10)
12 x Screw (#A)
12 x Nut (#B)
Installation:
• First, locate the post tubing on the
side of the Fire Bowl. Install the
Table Panel with Hole onto this side
of the Fire Bowl by inserting the
two pins into the fixed pin brackets.
Install the other Table Panels around
the Fire Bowl in the same manner.
Note illustration 4A.
IMPORTANT: The Table Panel with hole
must align with post tubing in order to
install Cooking Grid in later steps.
• Secure the Table Panels to the Fire
Bowl with a Table Support Bracket:
mount the bottom to the Fire Bowl
using a screw and nut (fastened
from the inside), mount the top to
the Table Panels with a screw and
nut (hole furthest from Fire Bowl).
Repeat for all sides. Complete the
installation using a screw and nut
to secure the Table Panels together
(hole closest to Fire Bowl). Note
illustration 4B.
3
4A
8
8
4B
10
B
A
A
8
9
7