Snmp - Motorola hellosecurity User Manual

2 megapixel lpr network camera

Table of Contents

Network Camera User Manual

4. Click the "Save" button to save the settings.

4.6.5 SNMP

To get camera status, parameters and alarm information and remotely manage the camera, the

SNMP function can be used. Before using SNMP, please install an SNMP management tool

and set the parameters of the SNMP, such as SNMP port, trap address.

1. Go to ConfigNetworkSNMP.

2. Check the corresponding version checkbox (Enable SNMPv1, Enable SNMPv2, Enable

SNMPv3) according to the version of the SNMP software that will be used.

3. Set the values for "Read SNMP Community", "Write SNMP Community", "Trap Address",

"Trap Port" and so on. Please make sure the settings are the same as that of the SNMP

software.

Table of Contents