Port; Server Configuration; Ddns - Motorola hellosecurity User Manual

2 megapixel lpr network camera

Table of Contents

Network Camera User Manual

4.6.2 Port

Go to ConfigNetworkPort interface as shown below. HTTP port, Data port and RTSP

port can be set.

HTTP Port: The default HTTP port is 80. It can be changed to any port which is not

occupied.

HTTPS Port: The default HTTPs port is 443. It can be changed to any port which is not

occupied.

Data Port: The default data port is 9008. Please change it as necessary.

RTSP Port: The default port is 554. Please change it as necessary.

This function is mainly used for connecting network video management system.

1. Check "Enable".

2. Check the IP address and port of the transfer media server in the ECMS/NVMS. Then

enable the auto report in the ECMS/NVMS when adding a new device. Next, enter the

remaining information of the device in the ECMS/NVMS. After that, the system will

automatically allot a device ID. Please check it in the ECMS/NVMS.

3. Enter the above-mentioned server address, server port and device ID in the corresponding

boxes. Click the "Save" button to save the settings.

If the camera is set up with a DHCP connection, DDNS should be set for the internet.

1. Go to ConfigNetwork DDNS.

Table of Contents