Alarm In - Motorola hellosecurity User Manual

Network Camera User Manual
3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.

4.4.3 Alarm In

To set sensor alarm (alarm in):
Go to ConfigAlarmAlarm In interface as shown below.
1. Click "Enable" and set the alarm type, alarm holding time and sensor name.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
3. Click "Save" button to save the settings.
4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as the
schedule recording setup. (See Schedule Recording).
For the model with two alarm input interfaces, you shall select the sensor ID first. Then set
the relevant trigger items. Click "Apply settings to" to quickly apply the settings to the other
alarm input.
24