Network Camera User Manual
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same
as motion detection. Please refer to
IP Address Conflict
1. Go to Config
Alarm
2. Click "Enable alarm" and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera is in conflict with the IP address of
other devices, the system will trigger the alarm out.
Cable Disconnection
1. Go to Config
Alarm
2. Click "Enable" and set the alarm holding time.
motion detection
Anomaly
IP Address Collision as shown below.
Anomaly
Cable Disconnected as shown below.
chapter for details.
23