Table of Contents
Advertisement
O For certain child restraint systems in weight
category II or III, there may be restrictions
on the maximum size setting, e.g. due to
possible contact with the roof.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be fitted facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust
the head restraints as appropriate.
° When fitting an i‑Size child restraint sys‐
tem, also observe the following:
O When using a rearward-facing child
restraint system: adjust the front seat so
that it does not touch the child restraint sys‐
tem.
O When using a forward-facing child
restraint system: the backrest of the child
restraint system must lie as flat as possible
against the backrest of the vehicle seat.
O You can have the head restraints of the rear
seats removed and installed by a qualified
specialist workshop. This may be necessary
for the use of certain child restraint sys‐
tems.
1
ISOFIX mounting bracket
2
i‑Size mounting bracket
Occupant safety
Before every journey, make sure that the ISOFIX
child restraint system or the i‑Size child restraint
system is engaged correctly in both mounting
brackets in the vehicle.
Remove and stow away covers
#
Attach the ISOFIX or i‑Size child restraint sys‐
#
tem to both mounting brackets in the vehicle.
After removing the child seat, reattach cov‐
#
ers
1
or 2.
Securing a Top Tether
& WARNING Risk of injury or death if the
rear seat backrests are not locked after
fitting Top Tether belts
The rear seat backrests may fold forwards
when driving.
In this case, child restraint systems may no
longer perform their intended protective
function. Additional injuries may also be
caused.
61
1
or 2.
Advertisement
Table of Contents
