Table of Contents
Advertisement
340 Wheels and tyres
rear wheels wear more in the centre of the
R
tyre
Do not drive with tyres that have too little tread
depth. This significantly reduces traction on wet
roads (aquaplaning).
On vehicles with the same front and rear wheel
size, you can interchange the wheels every
5000 to 10,000 km, depending on the wear.
Ensure the direction of rotation is maintained for
the wheels.
Observe the instructions and safety notes on
"Changing a wheel" when doing so
(
page 341).
/
Notes on storing wheels
When storing wheels, observe the following
notes:
After removing wheels, store them in a cool,
R
dry and preferably dark place.
Protect the tyres from contact with oil,
R
grease or fuel.
Overview of the tyre-change tool kit
* NOTE Mercedes-AMG vehicles
Observe the notes in the Supplement.
#
You could otherwise fail to recognise
dangers.
Apart from some country-specific variants, vehi‐
cles are not equipped with a tyre-change tool kit.
For more information on which tyre-changing
tools are required and approved for performing a
wheel change on your vehicle, consult a qualified
specialist workshop.
Required tyre-change tool kits may include, for
example:
Jack
R
Chock
R
Wheel wrench
R
Centring pin
R
%
The jack weighs approximately 3.4 kg.
The maximum load capacity of the jack can
be found on the identification plate on the
jack.
The jack is maintenance-free. If there is a
malfunction, please contact a qualified spe‐
cialist workshop.
The tyre-change tool kit is located in tool bag
1.
The tool bag contains:
Jack
R
Wheel wrench
R
Centring pin
R
Folding chock
R
Ratchet for jack
R
Advertisement
Table of Contents
